湘杰儀器提供D882-01_2
閱讀：568發布時間：2010-08-08
- 提供商
上海湘杰儀器儀表科技有限公司
- 資料大小
0K
- 資料圖片
查看
- 下載次數
0次
- 資料類型
- 瀏覽次數
568次
- 免費下載
拉力機；拉力機報價；拉力機維修Standard Test Method foTensile Properties of Thin Plastic Sheeting1This standard is issued under the fixed designation D 882; the number immediay following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon （e） indicates an editorial change since the last revision or reapproval.These test methods have been approved for use by agencies of the Department of Defense to replace Method 1013 of Federal TestMethod Standard 406.1. Scope*1.1 This test method covers the determination of tensile properties of plastics in the form of thin sheeting, including film （lessthan 1.0 mm （0.04 in.） in thickness）.NOTE 1—Film has been arbitrarily defined as sheeting having nominal thickness not greater than 0.25 mm （0.010 in.）.NOTE 2—Tensile properties of plastics 1.0 mm （0.04 in.） or greater in thickness shall be determined according to Test Method D 638.1.2 This test method may be used to test all plastics within the thickness range described and the capacity of the machineemployed.1.2.1 Static Weighing, Constant-Rate-of-Grip Separation Test—This test method employs a constant rate of separation of thegrips holding the ends of the test specimen.1.3 Specimen extension may be measured in these test methods by grip separation, extension indicators, or displacement of gagemarks.1.4 A procedure for determining the tensile modulus of elasticity is included at one strain rate.NOTE 3—The modulus determination is generally based on the use of grip separation as a measure of extension; however, the desirability of usingextensometers, as described in 5.2, is recognized and provision for the use of such instrumentation is incorporated in the procedure.1.5 Test data obtained by this test method is relevant and appropriate for use in engineering design.1.6 The values stated in SI units are to be regarded as the standard. The values in parentheses are provided for information only.1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibilityof the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatorylimitations prior to use.NOTE 4—This test method is similar to ISO 527-3, but is not considered technically equivalent. ISO 527-3 allows for additional specimenconfigurations, specifies different test speeds, and requires an extensometer or gage marks on the specimen.2. Referenced Documents2.1 ASTM Standards:
