IEPE是指一種自帶電量放大器或電壓放大器的加速度傳感器。IEPE是壓電集成電路的縮寫。因為由加速度傳感器產生的電量是很小的，因此傳感器產生的電信號很容易受到噪聲干擾，需要用靈敏的電子器件對其進行放大和信號調理。IEPE中集成了靈敏的電子器件使其盡量靠近傳感器以保證更好的抗噪聲性并更容易封裝。
美國Dytran的3006A是一款防潮型加速度傳感器/振動傳感器，靈敏度高，自帶電量放大器。
The Dytran 3006A is a moisture resistant, high sensitivity single axis IEPE accelerometer with an overall weight of 12 grams.
Featuring a stainless steel construction, 100 mV/g sensitivity, 10-32 mounting hole and low noise JFET electronics, the Dytran model 3006A incorporates a 10-foot integral cable with a splash-proof boot at the point of sensor and cable connection. The cable-to-accelerometer boot seal makes it possible for the sensor to be temporarily submerged during testing. Units are hermetically sealed for reliable operation in high humidity and dirty environments, and case isolated to avoid EMI/ground loop interference.
特性
1. 100 mV/g sensitivity
2. 50g range
3. 0.32 to 5,000 Hz frequency range (±5%)
4. 10-foot integral cable
5. 10-32 tapped hole
6. 12 grams
7. Stainless steel
8. Hermetic
9. Case isolated
10. Splash proof boot
11. Moisture resistant
12. IEPE
應用
1. Short-term immersion
短期浸入
2. Structural monitoring
結構監測
3. Vibration testing in damp environments
潮濕環境下的振動試驗
PHYSICAL
Weight, Less Cable, Max 0.42 oz 12 grams Supplied Accessories:
Mounting Provision : Tapped Hole 10-32 X .20 Deep 10-32 X .20 Deep
Cable Length 10 FT 25 m
Material : Base, Cap and Connector 300 S.S. 300 S.S.
Sensitivity, ±10% .
Range F.S for ± 5 Volts Output ±50 g ±490 m/s2
Frequency Range ±5% 0.32 to 5000 Hz 0.32 to 5000 Hz
±3 db 0.16 to 10000 Hz 0.16 to 10000 Hz
Resonant Frequency 35 kHz 35 kHz
Equivalent Electrical Noise Floor 0.00001 Grms 0.0001 m/s2 rms
Linearity [3] ± 1% % F.S. ± 1% % F.S.
Maximum Transverse sensitivity 5 % 5 %
Strain Sensitivity, Max 0.001 g/με 0.01 m/s2
Maximum Vibration ±600 G's,peak ±5886 m/s2 peak
Maximum Shock ±3000 G's,peak ±29430 m/s2 peak
Temperature Range -60 to+250 °F -54 to +121 °C
Seal, Accelerometer Hermetic Hermetic
Supply Current Range [4] 2 to 20 mA 2 to 20 mA
Compliance Voltage Range + 18 to +30 Volts + 18 to +30 Volts
Output Impedance,Typ 100 Ω 100 Ω
Bias Voltage +11 to +13 VDC +11 to +13 VDC
Discharge Time Constant 0.8 to 1.5 Sec 0.8 to 1.5 Sec
Output Signal Polarity for Acceleration Towards Top Positive Positive
Electrical Isolation, Case Ground to Mounting Surface 10 GΩ,min 10 GΩ,min
訂貨型號
3006A
配件
Supplied Accessories: (1) model 6200 mounting stud (10-32 to 10-32)
Recommended Accessories: model 4110C current source power unit
相關型號
3205B
3211M1
